St. Germain

Toorak, VIC

Project Details

Architect: Architectus

Builder: Maxcon Constructions

Contractor: FacadeX

Product: ShapeShell™-RC

Surface Area: 1,388 sqm

Application: Facade Cladding

Responsibility: Design, Engineer & Manufacture of Feature Elements

ShapeShift Technologies was engaged to design and supply the full GRC façade for St. Germain (Jackson House). Our scope encompassed the delivery of precision-engineered ShapeShell™-RC panels, tailored to achieve the architectural intent while ensuring durability and ease of installation.

The façade system was manufactured using advanced 5-axis CNC tooling, enabling complex geometries and consistent quality. Each GRC panel was integrated with a purpose-designed railing and fixing system, allowing for efficient on-site installation with minimal tolerance adjustments.

The result is a high-performance façade solution that balances lightweight construction with long-term strength, offering architectural flexibility, fire-rated performance, and a range of bespoke finishes to complement the building’s design vision.

Project overview

ShapeShift Technologies designed and supplied the full GRC facade for St. Germain in Toorak, Melbourne: 1,388 square metres of ShapeShell™-RC for architect Architectus and builder Maxcon Constructions. The panels were tooled on 5-axis CNC equipment and each one was integrated with a purpose-designed rail and fixing system so that installation needed minimal tolerance adjustment on site.

A facade is chosen on installed cost, not panel cost

Comparisons between facade materials almost always happen on a rate per square metre for the panel. That is the wrong number, and it is why facades get specified and then value-engineered out later.

The panel is usually the smaller part of the installed cost. The rest is the subframe, the brackets, the craneage or access equipment, and above all the labour, which is priced by how long a crew spends per panel at height. A cheaper panel that takes twice as long to align, or that needs a heavier support system behind it, costs more installed than a more expensive panel that goes up quickly.

That is the logic behind supplying the panel and its fixing system together. When the rail and the panel are designed as one product, the adjustment is engineered into the rail rather than improvised on site, and a crew can hang and align panels in a predictable cycle time. Minimal tolerance adjustment on site is a labour saving, and labour is where facade budgets are actually spent.

Why GRC weight matters on a residential building

GRC is a thin-section cement product, which makes it a fraction of the weight of solid precast for the same coverage. On a building like this the benefits compound: lighter panels need lighter brackets, lighter brackets need less structure behind them, and the whole facade can often be installed without the crane time that precast requires.

Being cement based also puts GRC in the material family used where a facade’s fire performance governs the selection, which is a different position from the polymer composites used for freeform sculptural work. That distinction is worth understanding before either is specified.

Machined tooling on a modest facade area

At 1,388 square metres this is not a large facade, and tooling cost is spread across fewer panels than it would be on a tower. Choosing 5-axis CNC tooling anyway is a decision about geometry: complex forms machined directly from the model come out consistent and repeatable, whereas hand-built moulds on a small run introduce variation exactly where there is no volume to average it out.

The finish range is part of the same reasoning. Because a GRC panel’s appearance comes from its mix and its mould surface rather than from a coating, bespoke finishes are a manufacturing choice rather than an applied layer with its own service life.

Related reading